A kitchen faucet that drips steadily no matter how tight you turn the handle, a bathroom faucet handle that's gone stiff or stuck, or low water pressure at a single fixture — faucet issues are usually a worn cartridge or valve, and usually a same-visit fix. Our Custer technicians carry common cartridges and O-rings for most major brands.
Common cartridges, O-rings, and valve stems are stocked for most major faucet brands sold in Custer.
Standard credentials apply whether it's a simple drip or a full installation.
A dripping faucet gets prompt scheduling since it wastes water continuously until repaired.
Pricing is confirmed upfront whether it's a cartridge swap or a full faucet replacement.
These are the faucet issues we see most often across Custer, SD.
A steady drip is almost always a worn cartridge, washer, or O-ring — replaced with the correct part for your specific brand.
Stiff handles, inconsistent temperature, or a faucet that won't shut off fully usually point to a failing cartridge.
We can install a faucet you've purchased or help recommend one that fits your existing setup.
Reduced flow at a single faucet is often a clogged aerator or a failing cartridge, not a whole-house pressure issue.
Outdoor spigots take more wear than indoor fixtures — we check for freeze damage as part of the repair.
A loose handle or mineral-clogged aerator is a quick fix that's often overlooked as a cause of poor faucet performance.
Describe the issue to dispatch — dripping, stiff handle, low pressure, or installation — to help route the right parts.
Trucks stocked for Custer, SD's common faucet brands mean fewer follow-up visits for parts.
The worn component is identified and a flat price quoted before any repair or installation begins.
We run the faucet through its full range before calling the job done, then back it with a warranty.
"Bathroom faucet handle was stiff and hard to turn. Turned out to be a simple valve replacement, not a whole new fixture." — Homeowner, Custer
"Outdoor spigot had frozen and cracked over winter. Fixed and upgraded to a frost-proof one." — Custer resident
"Matched the exact cartridge for our older faucet brand instead of suggesting we replace the whole thing." — Custer customer
We serve Custer proper and nearby Custer, SD communities for faucet repair and installation.
Tightening the handle doesn't fix a worn cartridge or O-ring — that internal part needs to be replaced.
It depends on the specific issue and brand — a cartridge swap costs far less than a full replacement. We quote upfront.
We'll identify the brand and model first and let you know if a special-order part is needed.
Usually a clogged aerator or a failing cartridge restricting flow, not a whole-house pressure problem.
Yes, we install customer-supplied faucets as long as they're compatible with your existing supply lines.
Yes — freeze damage is common, and we often recommend a frost-proof upgrade when repairing an outdoor spigot.
